Use this mode, e.g., if your Internet connection is provided by a remote access point, and you want to connect a subnet of your own to it. NAT or routing are performed between WAN and LAN, like in "normal" gateway or router mode. This would be more of a emergency option, say if the main line goes down so it should be easy to setup?Ĭlient mode – The radio interface is used to connect the Internet-facing side of the router (i.e., the WAN) as a client to a remote access point. I notice there is a iPhone optio under wan, but i suspect it wont work with android?
What would be the best way to use a mobile phones internet for the router WAN \ internet connection? Possible to capture syslog/klog, especially when 2.Posted: Sun 7:43 Post subject: ddwrt mobile usb tether or wifi hotspot WAN I'm having an odd issue where the 2.4 decides it doesn't want to allow anything to connect (but is visible) Posted: Fri 12:40 Post subject: Re: 2.4ghz wifi keeps failing, 5ghz is stable - Nighthawk R8 See the forum guidelines with helpful pointers about how to research your router, where and what firmware to download, where and how to post and many other helpful tips: Moved to Broadcom so that it will get better attention. And of course, if this isn't the right place for the question, feel free to remove it. I can't figure out where to begin since the 5ghz works just fine.Īs mentioned earlier, I haven't done anything wacky or advanced just stuck to the basic setup guide.Īny help would be appreciated. I have several IP cameras, light switches, and basic Wireless/ethernet hosts. All terminal commands from my computer return normal (aside from the 'no internet' message from the gui). When I log into the admin panel (while hardwired and on 5ghz), nothing seems amiss.
All have worked flawlessy for the past months. Only thing I have added is a usb mount, which is setup as a NAS SMB. I have set it using best practices according the basic setup documentation. I'm having an odd issue where the 2.4 decides it doesn't want to allow anything to connect (but is visible), yet the 5ghz is just fine. I just recently updated to latest beta build, but it was doing this before the upgrade I had hoped the upgrade would fix it. Many of the guides and posts here have been of great value. I'm rather new, but have been a lurker for a long time and have been using dd-wrt for years without issue. Since it seems to be more about dd-wrt than the router, I'll try here. Greetings, not sure if this is for general, or should be for my specific router. Posted: Tue 4:19 Post subject: 2.4ghz wifi keeps failing, 5ghz is stable - Nighthawk R8000
0 kommentar(er)
